HEIDENHAIN CNC PILOT 640 User Manual page 154

2
Cycle form:
E: Plunging behavior
E = 0: Descending contours are not machined
E > 0: Plunging feed rate for descending contour elements.
Descending contour elements are machined
No input: The plunging feed rate is reduced during machining
of descending contour elements by up to 50 %. Descending
contour elements are machined
B: TRC/MRC switch on – type of tool radius compensation
0: Automatic
1: Tool left (G41)
2: Tool right(G42)
3: Automatic w/o tool compens.
4: W/o tool compens. left (G41)
5: W/o tool compens. left (G42)
DXX: Add. correction number (range: 1 to 16)
Further information:
G58: Contour-parallel oversize
Further forms:
Further information:
With the address DXX you activate an additive
compensation for the entire cycle run. The additive
compensation is switched off again at the end of the
cycle. You edit additive compensation values in the
Program run submode.
Access to the technology database:
Machining operation: Finishing
Affected parameters: F, S, E
154
User's Manual
"smart.Turn unit", Page 78
smart.Turn units | Units – Finishing
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017