Monitoring Zone G995 - HEIDENHAIN CNC PILOT 640 User Manual

4

Monitoring zone G995

G995 defines the monitoring zone and the axes to be monitored.
The monitoring zone corresponds to the program section that is to
be monitored by the control.
To begin the monitoring zone, program G995 with the following
parameters. To end the monitoring zone, program G995 without
parameters.
Parameters:
H: No. of zone (range: 1 to 99)
ID: Axis code
X: X axis
Y: Y axis
Z: Z axis
0: Spindle 1 (main spindle, C axis)
1: Spindle 2
2: Spindle 3
The monitoring zones must be unambiguously defined
in the program. Use the H parameter to assign a unique
number to each monitoring zone.
If you would like to monitor more than one drive within
a monitoring zone, enter the respective combination
of individual parameters in the ID parameter. Please
keep in mind, however, that the control can monitor
a maximum of four drives per monitoring zone. To
simultaneously monitor the Z axis and the main spindle,
enter Z0 in the ID parameter.
In addition to defining the monitoring zone with G995,
you need to activate the load monitoring function.
Further information:
Page 449
Example: G995
. . .
N1 T4
N2 G995 H1 ID"X0"
. . .
N9 G995
. . .
448
"Load monitoring G996",
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
DIN/ISO programming | Other G codes
Beginning of monitoring zone; monitoring of X axis and main
spindle
Machining
End of monitoring zone