Touch Probe Cycles For Two-Point Measurement; Two-Point Meas. G18 Transverse G775 - HEIDENHAIN CNC PILOT 640 User Manual

Touch probe cycles | Touch probe cycles for two-point measurement
5.3 Touch probe cycles for two-point
measurement

Two-point meas. G18 transverse G775

Cycle G775 measures two opposite points in the X/Z plane with the
measuring axis X. If the tolerance values defined in the cycle are
exceeded, the cycle saves the measured deviation either as tool
compensation or as an additive compensation. The result of the
measurement is saved additionally in the variable #i99.
"Touch probe cycles for automatic mode",
Further information:
Page 521
Cycle run: From the current position the touch probe moves along
the defined measuring axis toward the measuring point. When the
stylus touches the workpiece, the measured value is saved and
the touch probe is positioned back to the starting point. For the
pre-positioning for the second measurement, the cycle first moves
the touch probe by the Circumnav. dir. offset RB and then by the
Measuring direction offset RC. The cycle executes the second
probing operation in the opposite direction, saves the result and
positions the touch probe back with the circumnavigation axis by
the circumnavigation value.
The control outputs an error message if the touch probe does
not reach any touch point within the defined measuring path.
If a Max. deviation WE was programmed, the measuring point
is approached twice and the mean value is saved as result. If
the difference of the measurements is greater than the Max.
deviation WE, the program run is interrupted and an error message
is displayed.
Parameters:
R: Type of correction
1: Tool compensation DX/DZ for turning tool or additive
compensation
2: Recessing tool DX/DS
3: Milling tool DX/DD
4: Milling tool DD
K: Incr. meas path w/ Ri. (the algebraic sign determines the
probing direction) – maximum measuring path for probing
E: Circumnavigation axis – selection of axis for retraction
movement between the probing positions
0: Z axis
2: Y axis
RB: Circumnav. dir. offset – distance
RC: Offset in X – distance for pre-positioning before the second
measurement
XE: Target pos. noml value X – absolute coordinate of touch
point
BD: Tolerance position +/ – measurement result range in which
no compensation is applied
X: -Nominal width in X – coordinate for the second probing
position
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
5
531