Fundamentals: Smart.turn Editor; Menu Structure - HEIDENHAIN CNC PILOT 640 User Manual

NC programming | Fundamentals: smart.Turn editor
1.2

Fundamentals: smart.Turn editor

Menu structure

You can select the following editor modes in the smart.Turn
operating mode:
Unit programming (standard)
ISO Mode (DIN PLUS and DIN 66025)
The menu structure of the smart.Turn operating mode is shown
in the figure at right. Many menu items are used in both modes.
The menus differ in the area of geometry and part programming.
In ISO Mode, the menu items Geo» (metry) and Mach» (ining)
are displayed instead of the menu items ICP and Units». You can
switch between the editor modes by soft key.
Switches between the Unit mode and ISO Mode
For special cases you can change to the text-editor mode in order
to edit character-by-character without syntax checking. The setting
is made in the Config Input mode menu item.
For a description of the functions, please refer to the following
chapters:
ICP functions
Further information:
Units for turning and C-axis machining
Further information:
Units for Y-axis machining
Further information:
Page 203
G codes for turning and C-axis machining (geometry and
machining)
Further information:
G codes for Y-axis machining (geometry and machining)
Further information:
Page 567
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
User's Manual
" smart.Turn units", Page 77
"smart.Turn units for the Y axis",
"DIN/ISO programming", Page 231
"DIN/ISO Programming for the Y axis",
1
47