Icp Face Milling Unit - HEIDENHAIN CNC PILOT 640 User Manual

2

ICP face milling unit

The unit mills the contour defined with ICP on the face of the
workpiece.
Unit name: G797_ICP / cycle: G797
Further information:
Contour form:
FK: ICP contour number
NS: Starting block no. of contour – beginning of contour
section
Z1: Upper edge of milling
Z2: Milling floor
X2: Limit diameter
Cycle form:
QK: Machining operation
Roughing
Finishing
J: Mill direction
0: Unidirectional
1: Bidirectional
H: Mill cutting direction
0: Up-cut
1: Climb
P: Maximum infeed
I: Contour-parallel oversize
K: Infeed-direction oversize
FZ: Approach feed (default: active feed rate)
E: Reduced feed
U: Overlap factor – defines the overlap of milling paths (default:
0.5) (range: 0 to 0.99)
Overlap = U * milling diameter
Further forms:
Further information:
Access to the technology database:
Machining operation: milling
Affected parameters: F, S, FZ, P
182
"Simple drilling G71", Page 373
"smart.Turn unit", Page 78
smart.Turn units | Units – milling, face (C axis)
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017