HEIDENHAIN CNC PILOT 640 User Manual page 11

Fundamentals | Software and features
The parameter D was added to G4 and G860, see "Period of
dwell G4", Page 439, see "Recessing G860", Page 327
The parameter B was added to G890, see "Contour finishing
G890", Page 335
The parameter RB was added to the units G840 Contour milling,
figures and G84X Pocket milling, figures, "Global form"
The parameters SP and SI were added to all tapping units, see
"Centric tapping unit", Page 107, see "Units – Drilling in C
axis", Page 110, see "ICP tapping, Y axis unit", Page 205
G48 was introduced to allow limiting the rapid traverse rate
for rotary and linear axes, see "Reduce rapid traverse G48",
Page 296
G53, G54 and G55 were introduced for datum shifts using offset
values, see "Datum shifts – G53/G54/G55", Page 306
The functions for superimposing axis movements Eccentric
turning G725, Eccentric transition G726 and Non-circular
X G727 were introduced, see "Eccentric turning G725",
Page 452, see "Eccentric transition G726", Page 453, see
"Non-circular X G727", Page 455
The load monitoring functions G995 Monitoring zone definition
and G996 Type of load monitoring were introduced, see
"Monitoring zone G995", Page 448, see "Load monitoring
G996", Page 449
The AWG submode now also supports tools with quick-
change holders, see "Tool selection and turret assignment list",
Page 636
A tree view is available in smart.Turn operating mode, see
"Editing with active tree view", Page 50
Skip levels can be defined in smart.Turn operating mode, see
"Skip level", Page 483
A function was introduced to query information on the tool
status, see "Reading diagnostic bits", Page 467
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
11