Full-Surface Machining With Turn Plus; Rechucking The Workpiece - HEIDENHAIN CNC PILOT 640 User Manual

7
7.6

Full-surface machining with TURN PLUS

Rechucking the workpiece

Refer to your machine manual.
Rechucking workpieces depends on the configuration of
your machine.
The control uses subprograms for rechucking which are
adapted by the machine tool builder.
TURN PLUS provides three full-surface machining variants:
Rechucking the workpiece in the main spindle. Both setups are
contained in one NC program
Transferring the workpiece from the main spindle to the
opposing spindle (chuck part)
Parting and picking-off the workpiece with the opposing spindle.
TURN PLUS selects the required rechucking variant on the basis of
the fixture and the machining sequence.
In the CfgExpertProgam machine parameters (no.
606800), a specific subprogram is defined for each
rechucking variant controlling the sequence of
rechucking.
650
TURN PLUS | Full-surface machining with TURN PLUS
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017