HEIDENHAIN CNC PILOT 640 User Manual page 524

5
O: Err. evaluation
0: Program—Do not interrupt program run, no error message
1: Automatic—interrupt program run and output error
message if touch probe is not deflected within measuring
path
F: Measuring feed – feed rate for probing (if nothing is entered,
the measuring feed rate from the touch probe table is used)
If the entered measuring feed rate F is higher than the one in
the touch probe table, the feed rate is reduced to the value from
the touch probe table.
Q: Tool orientation (machine-dependent)
Orient the touch probe in the programmed probing direction
before each probing operation.
P: PRINT outputs
0: OFF – do not display measuring results
1: ON – display measuring results on the screen
H: INPUT instead of measure
0: Standard – obtain measured values by probing
1: PC test – simulate touch probe cycle on the programming
station
AN: Log no. – save measurement results in the
TNC:\table\messpro.mep table (line numbers 0-99)
The table can be expanded if necessary.
Example: G770 Single-point meas. for tool comp.
. . .
MACHINING
N3 G770 R1 D0 K20 AC0 BD0.2 WT3 V1 O1 Q0P0 H0
. . .
524
Touch probe cycles | Touch probe cycles for single-point measurement
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017