Installing The Mx2020 Upper Cable Manager - Juniper MX2020 Hardware Manual

Figure 272: Installing the Standard Lower Cable Manager
SEE ALSO
Removing the MX2020 Lower Cable Manager | 618

Installing the MX2020 Upper Cable Manager

NOTE: To accommodate additional clearance, you may order an extended upper cable manager
from Juniper Networks.
To install the upper cable manager (see
1. Position the upper cable manager on the studs on the upper front of the chassis, just below the craft
interface.
2. Insert the screws into the corners in the upper cable manager onto the studs on the chassis.
3. Using a Phillips (+) screwdriver (number 1 or 2), tighten the mounting screws securely.
4. Replace the cable manager cover, and secure the two captive screws.
Figure 273 on page 622):
621