Rud To Ele (Air Only) - FUTABA T12K Instruction Manual

RUD to ELE
This function is used when you want to mix
elevator operation with rudder operation. It is used
to correct undesirable tendencies when rudder is
applied in rolling maneuvers such as knife edge
flight.
● Select [RUD to ELE] at the Model
menu and access the setup screen
shown below by pushing the RTN
button.
● Select the function name
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Setting method
●Activate the function
Move the cursor to the [ACT] item and push
the RTN button to switch to the data input
mode. Select the ACT mode by scrolling the
Push dial.
*The display blinks.
Push the RTN button to activate the function
and return to the cursor mode. (ON is
displayed.)
When selecting a switch, move the cursor to
the [SW] item and push the RTN button to call
the selection screen. Select the switch and
set its ON direction. (Always ON at "--" setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●5-point curve setting (airplane)
[Curve rate setting]
1. Move the cursor to the curve rate setting
item (left side) you want to adjust and push
the RTN button to switch to the data input
mode.
Adjust the rate by scrolling the Push dial.
Adjustment range: -100%~+100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to end the adjustment
and return to the cursor mode.
2. Repeat this procedure for each point.
166 <Model Menu (Airplane/Glider/Multirotor Functions)>
[Corresponding model type]: Airplane, general
● Mixing during flight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
● Link mixing can be set: Links this mix to other mixes.
[Moving curve point]
1. Move the cursor to the curve point setting
item you want to adjust and push the RTN
button to switch to the data input mode.
Adjust the curve point by scrolling the Push
dial.
Adjustment range: Up to 2.5% in front of the
adjoining point
*When the RTN button is pushed for one second, the curve
position is reset to the initial value.)
Push the RTN button to end the adjustment
and return to the cursor mode.
2. Repeat this procedure for each point.
[Deleting/returning curve point]
Move the cursor to the curve point setting
item you want to delete/return and push the
RTN button for one second.
●Link mode setting
When selecting the link mixing, move the
cursor to the [LINK] item and push the RTN
button to switch to the data input mode.
Select the ON mode by scrolling the Push
dial.
*The display blinks.
Push the RTN button to set the link mode and
return to the cursor mode.
<Push Dial>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered