Table of Contents
Advertisement
TELEM.SET.
This screen does the following setting of
telemetry.
Telemetry speech
Telemetry logging
Telemetry alarm
● Select [TELEM.SET.] in the Linkage menu and
access the setup screen shown below by pushing
the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
The speech language installed is
indicated. When the speech data is
not installed, "----------" is displayed.
The version No. of the speech data
file is indicated. When the speech
data is not installed, nothing is
displayed.
The interval of speech can be set.
The setting range is from 0 [Sec] to
30 [Sec].
Telemetry Data Logging
You must have a micro SD card inserted to use data logging.
ACT/INH button, ON/OFF switch and INTERVAL button has been added to "TELEM.SET." screen.
When the LOGGING is set to ACT and ON, data will be logged based on the INTERVAL set.
Telemetry setting
*It cannot be used in S-FHSS mode
Logging ON/OFF switch
ACT/INH
Logged data is written to
the SD at the interval input
here
<Push Dial>
● To input data mode
● Data is entered
● To next page
When the logging function
is ON, "ON" is displayed
here. Logging ON/OFF
switch.
<Functions of Linkage Menu>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
97
Advertisement
Table of Contents
