Table of Contents
Advertisement
AIRBRAKE
This function is used to increase the aircraft's
drag and is useful for landing or diving, etc.
The preset ailerons, elevators, rudder and flaps
(camber flap, brake flap) offset amount can be
activated by a switch.
The offset amount of the aileron, elevator,
rudder and flap servos can be adjusted as needed.
Also, the speed of the aileron, elevator, rudder
and flap servos can be adjusted. If the Auto Mode
is activated, this will link the Airbrake to a stick,
switch, or dial. A separate stick switch or dial can
also be set as the ON/OFF switch.
● Select [AIRBRAKE] at the Model menu and access
the setup screen shown below by pushing the RTN
button.
● Select the function name
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
● S w i t c h
selection
[Corresponding model type]: Airplane, 2 ailerons or more
● Ailerons, flaps, rudder and
elevators offset rate
●Auto switch selection
<Model Menu (Airplane/Glider/Multirotor Functions)>
Setting example for F3A and other flaperon specifications
(When 2 ailerons model type selected)
Offset rate:
AIL: [-35~-45%], AIL2: [-35~-45%], ELE: [+5~7%]
Note: The input numerics are examples. Adjust the travel to
match the aircraft.
Mode setting:
ACT: [ON]
Switch: [SW-C]
AUTO-SW: [--]
*The display screen is an example. The
actual screen depends on the model type.
<Push Dial>
● Ailerons, flaps, rudder
and elevators servo
speed setting
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
● To next page
157
Advertisement
Table of Contents
