Table of Contents
Advertisement
THR HOLD
This function sets the throttle cut position for
auto rotation. The throttle servo operating speed
can be adjusted. (Speed)
● Select [THR HOLD] at the Model menu
and access the setup screen shown
below by pushing the RTN button.
● Select the function name
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
●Hold position setting
Setting method
●Hold condition switch selection
Use the Condition select menu of the Model
menu to assign the hold condition switch.
Selection example: SG
●Hold position adjustment
Move the cursor to the hold position item
and push the RTN button to switch to the
data input mode.
Adjust the rate by scrolling the Push dial.
Initial value: 17%
Adjustment range: 0%~50%
*Hold position sets the throttle cut position. Adjust it so that
the carburetor is completely closed.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to end the adjustment
and return to the cursor mode.
Note: Initially, this setting does not assign the
throttle hold switch. Prior to adjusting the
parameters for the throttle hold, we suggest
designating a throttle hold switch. To do so,
access the Condition menu within the Model
menu options.
●Servo speed
●Servo speed setting
Move the cursor to the servo speed item and
push the RTN button to switch to the data
input mode.
Adjust the rate by scrolling the Push dial.
Initial value: 0
Adjustment range: 0~27 (maximum delay)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to return to the cursor
mode.
Operation precautions
Warning
When starting the engine and flying, always
set the idle up condition switch to OFF and
start the engine at idle.
<Functions of Model Menu (Helicopter Functions)>
<Push Dial>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
●Hold position
●Current position
177
Advertisement
Table of Contents
