Table of Contents
Advertisement
IDLE DOWN
The Idle Down function lowers the engine to
its idle position. Like throttle cut, this is usually
accomplished by flipping a switch with the throttle
stick at idle. The action is not functional at high
throttle to avoid accidental dead sticks. The
switch's location and direction must be chosen, as
it defaults to NULL.
● Select [IDLE DOWN] in the Linkage menu and
access the setup screen shown below by pushing
the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Idle down setting procedure
1. Activate the function:
Move the cursor to the [ACT] item and push
the RTN button to switch to the data input
mode.
Select the ACT mode by scrolling the Push
dial.
*The display blinks.
Push the RTN button to activate the function
and return to the cursor mode.
2. Switch selection:
Move the cursor to the [SW] item and access
the switch setup screen by pushing the RTN
button. Select the switch and ON direction.
*For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.
3. Offset rate setting:
Move the cursor to the [OFFSET] item and
push the RTN button to switch to the data
input mode.
Adjust the servo offset rate at idle down
operation by scrolling the Push dial.
Initial value: 0%
Adjustment range: -100%~0%~+100%
Lowers the engine idling speed (airplane only)
● Current throttle position
<Push Dial>
* When a minus rate is input, an offset is applied at the high
side.
*Maximum offset amount is near maximum slow.
* When the RTN button is pushed for one second, the offset
rate is reset to the initial value.
Push the RTN button to end the adjustment
and return to the cursor mode.
<Functions of Linkage Menu>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
89
Advertisement
Table of Contents
