Table of Contents
Advertisement
7. Move the cursor to the [--] item and push
the RTN button.
8. [SF] is chosen by [H/W SELECT] and then a
bottom is turned ON by pushing the RTN
button.
9. [MODE] and [RATE] of a state of "#2=SF
bottom"are set up.
SF : Bottom = #2
*If the 3 position switch is chosen, 3 rate changes can be
performed.
*Combined use of two or more switches cannot be performed.
186
<Functions of Model Menu (Helicopter Functions)>
●CAL (Calibration)
This function transmits a reference signal from
the transmitter for setting the governor's side
speed display. The governor and transmitter
set values (speed display) can be matched.
*The CAL button can only be displayed in rpm mode.
The number
●
1. Move the cursor to the CAL button and
of a SW state
push the RTN button.
2. The display switches to the screen that
transmits the reference signal.
3. Move the cursor to OFF and push the RTN
button.
4. Once it scrolls to the mode of your choice,
push the RTN button.
5. Set the transmitter's displayed speed. Adjust
the governor's speed display on its side.
(Refer to your governor's instruction manual
on how to make proper adjustments).
In "ON", "CAL" appears
Button added to the reference signal output screen.
(Displayed only in the rpm mode.)
Advertisement
Table of Contents
