FUTABA T12K Instruction Manual page 82

Camber/Motor/Butterfly control setting (glider)
*Camber/motor/butterfly function control can be changed for
each condition.
Camber, motor or butterfly control group/
single setting is performed at the function
setup screen.
"G": Group (common to all conditions)
"S": Single (set for each condition)
Trim setting
Move the cursor to the "TRIM" item of the
channel you want to change and push the
RTN button.
*The trim setup screen is displayed.
The following items can be set at the trim
setup screen:
Trim selection
Move the cursor to the trim, lever, etc. you
want to set and push the RTN button.
*The setting can be changed.
Trim rate setting
Move the cursor to the [RATE] item and push
the RTN button to switch to the data input
mode.
Set the trim rate by scrolling the Push dial.
Initial value: +30%
Adjustment range : -150~+150%
(When the RTN button is pushed for one second, the trim rate
is reset to the initial value.)
Push the RTN button to end adjustment and
return to the cursor mode.
Trim mode selection
Move the cursor to the [MODE] item and
push the RTN button to switch to the data
input mode.
Select the trim mode by scrolling the Push
dial. A confirmation message appears. Push
82 <Functions of Linkage Menu>
the RTN button to change the mode. (To
terminate input and return to the original
state, push the S1 button.)
[NORM]: Normal mode. Normal trim (parallel
shift trim) operation.
[ A T L ] : A T L o p e r a t i o n m o d e . M a x i m u m
change near idle or low-stick position,
normally used with throttle trim. It is also
possible to reverse the travel.
*[NORMAL]/[REVERSE] selection is possible in "ATL"
mode.
Throttle trim (helicopter only)
* The throttle trim in conditions other than "normal" condition
can be inhibited.
W h e n o t h e r t h a n n o r m a l c o n d i t i o n i s
selected, move the cursor to throttle trim on
the function setup screen and push the RTN
button for 1 second.
*When "X" is displayed, THR trim is inhibited in conditions
other than normal condition.
Channel replacement
Move the cursor to the channel # you want
to replace and push the RTN button to switch
to the data input mode.
Select the destination channel # by scrolling
the Push dial. A confirmation message
appears. Push the RTN button to replace the
channel. (To terminate input and return to
the original state, push the S1 button.)