Aux Ch; Trim; Flaperon (Acro Only) - FUTABA T8J FUT01004369-3 Instruction Manual

Auxiliary channel function ( AUX-CH
Remember that if you assign primary control of a channel to a switch which you later use for other functions (like
dual/triple rates or airbrakes), every time you use that other function you will also be moving the auxiliary channel.
GOAL of EXAMPLE:
Assign flaps to the digital trim [DT5]
and set channel 7 to NULL in preparation
to use it as a smoke system control (the
smoke system being activated later by a
Where next?
WARNING
The priority of AUX
Don't assign two or more functions to one channel.
Priority may be given to a higher rank function and
a low rank function may be canceled.
Adjustability:
and DT6), or KNOB [VR].
• Multiple channels may be assigned to the same switch, trim or knob.
• Channels set to "NULL" are only controlled by mixes. (Ex: utilizing 2
channels for 2 rudder servos.)
• If GYRO SENSE , GOVERNOR , and THR-NEEDLE functions are activated, AUX-CH
settings of related channels become invalid automatically.
Related channels:
GYRO SENSE ( ACRO / HELI ): ch. 5, 7, or 8: see p. 64 and p. 87
GOVERNOR ( HELI ): ch. 7, or ch. 7 and 8: see p. 89.
THR-NEEDLE ( ACRO / HELI ): ch. 8: see p. 62.
STEPS:
Open AUX-CH function.
Choose the channel to change. (ex: ch.
6.)
Change primary control. (ex: to digital
trim [DT5].)
Repeat as needed. (ex: ch. 7 to NULL .)
Close.
Programmable mixes: see p. 65.
Set up dual/triple rates and exponential ( D/R , EXP ): see p. 39.
Adjust SUB-TRIM of auxiliary channel to adjust center SWITCH position:
see p. 46.
Adjust END POINTs (sets end points of travel even when using a switch):
see p. 36.
CH5
CH6
ACRO
CH7
CH8
CH5
CH6
HELI
CH7
CH8
SWITCH (A-H), TRIM LEVER (DT5
INPUTS:
for 1 second.
to AUX-CH .
to Ch 6 .
to DT5 .
to Ch 7 .
higher rank Priority
PIT GYRO
FLAP TRIM FLAPERON
AIL-DIFF GYRO
AILVATOR PIT THR→NEEDL
GYRO
PIT
GYRO GOVERNOR
ELE2 THR→NEEDL
43
to NULL .
low rank
SW-G
VR
DT5
GYRO DT6
SW-F
SW-C
GYRO GOVERNOR VR