Rud To Ele - FUTABA FX40 Instruction Manual

RUD to ELE

This function is used when you want to mix
elevator with rudder operation. It is used to correct
undesirable tendencies when rudder is applied in
roll maneuvers, knife edge, etc. of stunt planes.
call the setup screen shown below.
items are displayed.
to call the <Switch> screen, and then select the
(For a description of the switch setting method,
see the description at the back of this manual.)
button to call the <Switch> screen, and then
direction can be set.
method, see the description at the back of this
manual.)
operation (switch operation) is performed with
the stick position at that time is displayed on the
(Fine tuning)
(For more information, see the description at the back of
this manual.)
(For a description of the curve setting method, see
the description at the back of this manual.)
(Example) Using the memory function with an F3A
airplane (knife edge correction)
*When call switch [SW-A] and memory switch
[SW-H] were set
while performing elevator correction when
rudder was applied at knife edge, the point
is performed while changing the left and right
stick positions.
curve, and operation is simultaneously set.
the memory SW is not accidentally set to ON and incorrect
mixing setting is not applied when taxiing, starting the engine,
etc.
<Model Menu (Airplane/Glider Functions)>
adjustment
105