Switch Setting Method - FUTABA T12K Instruction Manual

Switch Setting Method

The various functions used in the T12K can
be activated by a switch. For the purposes of this
manual, a stick position, VR position, etc. shall
be commonly referred to as a switch in all cases.
Switch selection
When a switch is selected at a mixing function, etc., the selection screen shown below appears.
Switch selection
1. Use the Push dial to move the cursor
(highlights) to the switch you want to
select and push the RTN button.
*The switch blinks.
2. To return to the preceeding screen, move
the cursor to the [H/W SELECT] at the top
of the screen and push the RTN button.
Or, move the cursor to the [ON/OFF] and
call the ON/OFF position setting screen by
pushing the RTN button.
When the switch is selected
Once the switch is selected, the ON/OFF
setting is also activated.
*The ON/OFF setting state of each position is displayed.
1. When you want to change the ON/OFF
setting, use the Push dial to move the
cursor and push the RTN button to switch
to the data input mode. Switch the ON/
Off display by scrolling the Push dial.
*ON/OFF display blinks.
2. When the RTN button is pushed, the ON/
OFF setting is changed. (Push the S1
button to stop the change.)
3. To return to the preceeding screen, move
the cursor to the [ON/OFF] at the top of
the screen and push the RTN button.
190 <Appendix>
Whenever the manual indicates that something is
operated via a switch, it is possible for the user to
activate this setting via a stick, stick position, etc.
(Switch selection screen example)
switch, two operation modes can be selected:
1. When you want to change the mode,
●Mode: [LIN]/[SYM]
*Set the ON/Off point by the method described on the next page.
Alternate mode setting
●ALTERNATE mode: [OFF]/[ON]
1. Move the cursor to the [ALTERNATE] item
and push the RTN button to switch to the
data input mode.
2. Change to the mode you want to set by
scrolling the Push dial.
*The mode display blinks.
3. Push the RTN button. (Push the S1 button to
stop the change.)
4. To return to the preceeding screen, move
the cursor to the [ON/OFF] at the top of the
screen and push the RTN button.
When stick, trim lever, or knob selected
When a stick, trim lever, or knob is used as a
move the cursor to [MODE] item and push
the RTN button to switch to the data input
mode. Switch the display to the mode you
want to change by scrolling the Push dial
and then make the change by pushing
the RTN button.