Table of Contents
Advertisement
WINGLET
This function adjusts the left and right rudder
angles of airplanes with winglets.
Winglets are used to improve the efficiency of
aircraft by lowering the lift-induced drag caused by
wingtip vortices. The winglet is a vertical or angled
extension located at the tip of each wing.
Winglets work by increasing the wing's effective
aspect ratio without adding to the structural
stress and weight of its structure. An extension of
wingspan would also permit lowering of induced
drag, though it requires boosting the wing's
strength and weight. A winglet helps solve this
by effectively increasing the aspect ratio without
adding to the wingspan.
● Select [WINGLET] at the Model menu
and access the setup screen shown
below by pushing the RTN button.
● Select the function name
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Setting method
● Travel adjustment
Move the cursor to the item you want to
adjust and push the RTN button to switch to
the data input mode.
Adjust the rate by scrolling the Push dial.
Initial value: +100%
Adjustment range: -120~+120%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to return to the cursor
mode.
*If the mixing direction is reversed, change the mixing rate
polarity (+ or -).
[Corresponding model type]: Airplane/glider, Flying wing only
(Rudder 1/2)
● The travel during rudder stick operation
can be individually adjusted.
<Model Menu (Airplane/Glider/Multirotor Functions)>
RUDDER 1
(
)
Winglet
at Flying wing
<Push Dial>
RUDDER 2
(
)
Winglet
at Flying wing
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
163
Advertisement
Table of Contents
