Model Select - FUTABA T12K Instruction Manual

MODEL SELECT

This function is used to load the settings of the
desired model into the T12K's memory.
The settings may be selected from either the
transmitter's internal memory or a micro SD card.
Remember that up to 30 model memories are available
in the transmitter.
The name of the model stored in the transmitter
and the micro SD card may be changed. This can be
very useful to tell different models settings apart. Each
model name can be as long as 10 characters, and the
model name always appears in the display screen.
● Select [MODEL SELECT] in the Linkage menu and
access the setup screen shown below by pushing
the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Model selection
*Model data saved on the transmitter memory other than the
model currently used can be selected.
1. Move the cursor to the save destination
display ("TX" or "CARD") and push the RTN
button to switch to the data input mode.
Select the save destination by scrolling the
Push dial and push the RTN button.
[TX]: Transmitter memory
[CARD]: micro SD card
2. After moving the cursor to the desired model
in the model list, push the RTN button.
3. Move to [SELECT].
4.Push the RTN button. A confirmation message
is displayed. Push the RTN button for one
second and selection is complete.
*Transmission stops and then starts in the new model.
76 <Functions of Linkage Menu>
The Model Selection function performs model addition, selection,
deletion, copy, and model name setting.
The Copy function is used to copy parameters,
settings, etc. from one model data into a second
memory. It may be used for getting a head-start on
setting up models with almost the same settings (only
differences need to be modified, instead of entering the
complete model from scratch). Also, this function may
be used to make a backup copy of a model setup before
any changes are made.
(Model list)
Model addition
*A new model can be added to the transmitter memory. It
1. Move the cursor to [NEW].
2. Push the RTN button. A confirmation message
appears. Push the RTN button for one
second.
*The model type setup screen and frequency setup screen are
*Transmission stops and then starts in the new model.
*The added model appears in the model list of the model
*Link is required when a new model is
Current model
<Push Dial>
*The display screen is an example. The
screen depends on the model type.
cannot be added to the micro SD card.
automatically displayed. Confirm or change the model type
and SYSTEM mode.
select setup screen.
made from a model selection.
Scrolling
● Moving cursor
● Selecting mode
● Data is entered