Table of Contents
Advertisement
Curve setting examples
The curves shown below are created by inputting
the data of the 5 points for each condition, 0%
(low side), 25%, 50% (center), 75%, 100% (high)
●Throttle Curve (Example)
Normal Curve
Throttle Hover trim
[Throttle hover trim setting]
Setting method
● Set the function to ACT ([ON]). (initial setting)
● Select the adjustment knob.
Selection example: RD (initial setting)
● The trim operation mode (Mode: CTRM/
NORM) can be selected.
CTRM mode: Maximum rate of change
n e a r c e n t e r b y c e n t e r t r i m o p e r a t i o n
(recommended)
N O R M m o d e : N o r m a l t r i m ( h o r i z o n t a l
movement trim) operation.
● The trim rate can be adjusted and the
operation direction can be set.
● Trim adjustment range (Range) setting
With smaller values, the trim is only active
near the center.
side. When creating a curve, enter the parameters
specified per the model (or the reference value).
Idle-up 1 Curve
Idle-up 2 Curve
<Functions of Model Menu (Helicopter Functions)>
175
Advertisement
Table of Contents
