Table of Contents
Advertisement
FLAP SET.
The up/down travel of each flap (camber flaps:
FLP1/2, brake flaps: FLP3/4) can be adjusted
independently for each servo according to the
wing type.
● The operation reference point of each flap can be
offset
The camber flaps of a 4-flap model can
be mixed with the brake flaps. (BRKFLP to
CMBFLP)
● An ON/OFF switch can be set.
● Select [FLAP SET.] at the Model menu and access the setup
screen shown below by pushing the RTN button.
● Select the function name
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
● U p / D o w n
adjustment
Setting method
●Flap up/down adjustment
Move the cursor to the flap (FLP) 1~4 Up or
Down item according to the wing type and
push the RTN button to switch to the data
input mode. Adjust the travel independently
by scrolling the Push dial.
Initial value: +100%
Adjustment range: -120~+120%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to end the adjustment
and return to the cursor mode.
●Reference point adjustment
Move the cursor to the [OFFSET] item and
push the RTN button to switch to the data
input mode. Adjust the operation reference
point of each flap by scrolling the Push dial.
Initial value: 0%
Adjustment range: -100~+100%
142
<Model Menu (Airplane/Glider/Multirotor Functions)>
[Corresponding model type]: Airplane/glider, 2 flaps or more
●Operation reference
point offset
Push the RTN button to end the adjustment
●Activate the Brake FLP to Camber FLP mixing
Move the cursor to the [ACT] item and push
Push the RTN button to activate the function
FLP 3
(Brake Flap)
FLP 1
(Camber Flap)
*The display screen is an example. The actual
screen depends on the model type.
<Push Dial>
(Glider: Currently selected condition name)
*When the RTN button is pushed for one second, the
reference point is reset to the initial value.)
and return to the cursor mode.
the RTN button to switch to the data input
mode. Select the ACT mode by scrolling the
Push dial.
*The display blinks.
and return to the cursor mode. (ON is
displayed.)
To select a switch, move the cursor to the
[SW] item and push the RTN button to call the
selection screen. Select the switch and set its
ON direction. (Always ON at "--" setting)
*For a description of the switch selection method, see the
description at the back of this manual.
FLP 4
(Brake Flap)
FLP 2
(Camber Flap)
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
● To next page
Advertisement
Table of Contents
