Table of Contents
Advertisement
PIT to RUD mixing (Revolution mixing)
Use this mix when you want to suppress the
torque generated by main rotor pitch and speed
changes during pitch operation. Adjust so that the
nose does not move in the rudder direction.
● Select [PIT to RUD] at the Model menu and access
the setup screen shown below by pushing the
RTN button.
● Select the function name
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Setting method
●Activate the mixing
When using this function, move the cursor to
the [ACT] item and push the RTN button to
switch to the data input mode.
Select the ACT mode by scrolling the Push
dial.
*The display blinks.
Push the RTN button to activate the mixing
and return to the cursor mode. (ON is
displayed.)
●5-point curve setting
Move the cursor to the curve rate setting
item you want to adjust and push the RTN
button to switch to the data input mode.
Adjust the rate by scrolling the Push dial.
Initial value: P1~P5: 0%
Adjustment range: -100%~+100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to end the adjustment
and return to the cursor mode.
Repeat this procedure for each point.
●Pitch curve copy function
Move the cursor to COPY item and push the
RTN button to switch to the data input mode.
Select the copy destination condition by
scrolling the Push dial and pushing the RTN
button. Select the [YES] and push the RTN
button.
180
<Functions of Model Menu (Helicopter Functions)>
Note: When a GY Series or other heading hold
gyro is used, since correction is performed by
the gyro, this mix is not utilized. If this function
is used when the gyro operation mode is the
AVCS mode, the neutral position will change.
(Currently selected condition name)
<Push Dial>
<Normal condition mixing curve>
The mixing curve rate should be started
using smaller values.
For a rotor with a clockwise operation
direction, when pitch was input at the plus
side, set these parameters so that mixing
is in the clockwise direction. First, trim at
hovering and then adjust the neutral
position.
1. Adjustment between slow and hovering
Repeatedly hover from take off and land
at a constant rate matched to your own
rhythm. Adjust the pitch so that the nose
of the helicopter remains steady when the
throttle is raised and lowered.
2. Throttle high side (climbing and diving
from hovering)
Repeat climbing and diving from hovering
at a constant rate matched to your own
rhythm and adjust the pitch so that the
nose does not deflect when the throttle is
raised and lowered.
<Idle up condition mixing curve>
Set the mixing rate so that the rudder direction
at high-speed flight is straight ahead. Adjust for
each condition used.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
Advertisement
Table of Contents
