Table of Contents
Advertisement
END POINT
The End Point function adjusts the left and right
servo throws, generates differential throws, and
will correct improper linkage settings.
The travel rate can be varied from 0% to 140%
in each direction on channels 1 to 12 (T-FHSS Air).
Also, the limit point where servo throw stops may
be varied from 0% to 155%.
● Select [END POINT] in the Linkage menu and
access the setup screen shown below by pushing
the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Servo travel adjustment
1. Move the cursor to the travel icon of the
channel you want to adjust and push the
RTN button to switch to the data input mode.
2. Adjust the rate by scrolling the Push dial.
Initial value: 100%
Adjustment range: 0%~140%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
Push the RTN button to end adjustment and
return to the cursor mode.
3. Repeat this procedure for each rate.
Limit point adjustment
1. Move the cursor to the limit point icon of the
channel you want to adjust and push the
RTN button to switch to the data input mode.
2. Adjust the limit point by scrolling the Push
dial.
Initial value: 135%
Adjustment range: 0%~155%
*When the RTN button is pushed for one second, the limit
point is reset to the initial value.
Push the RTN button to end adjustment and
return to the cursor mode.
3. Repeat this procedure for each limit point.
86
<Functions of Linkage Menu>
Sets the travel and limit point of each servo.
(limit point)
(travel)
(The display screen is an example. The
screen depends on the model type.)
<Push Dial>
(limit point)
(travel)
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
● To next page
Advertisement
Table of Contents
