FUTABA T12K Instruction Manual page 149

Setting method
●Activate the function
Move the cursor to the [ACT] item and push
the RTN button to switch to the data input
mode. Select the ACT mode by scrolling the
Push dial.
*The display blinks.
Push the RTN button to activate the function
and return to the cursor mode. (ON is
displayed.)
When setting a switch, move the cursor to
the [SW] item and push the RTN button to call
the selection screen. Select the switch and
set its ON direction. (Always ON at "--" setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Condition delay setting
Move the cursor to the [COND.DELAY] item
and push the RTN button to switch to the
data input mode. Adjust the condition delay
by scrolling the Push dial.
Initial value: 0
Adjustment range: 0~27
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to end the adjustment
and return to the cursor mode.
When setting a cut switch, move the cursor
to the [CUT-SW] item and push the RTN
button to access the selection screen. Select
the switch and set its ON direction. (Always
ON at "--" setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Rate adjustment
The rates are adjusted by accessing the
aileron, flap, and elevator rate screens.
Move the cursor to the rate1 or rate2
item and push the RTN button to switch
to the data input mode. Adjust the rate
independently by scrolling the Push dial.
Initial value: 0%
Adjustment range: -100~+100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to end the adjustment
and return to the cursor mode.
●3 Camber points
AIL 3
(Chip Aileron)
ELEVATOR
<Model Menu (Airplane/Glider/Multirotor Functions)>
A button for setting 3 Camber
points.
The screen at Airplane
The screen at Glider
3 points setting of Camber function
FLP 4
FLP 3
(Brake Flap)
(Brake Flap)
FLP 1 FLP 2
(Camber Flap) (Camber Flap)
AIL1
(Main Aileron)
V-TAIL AILEVATOR
ELEVATOR
ELEVATOR 2
AIL 2
(Main Aileron)
AIL 4
(Chip Aileron)
ELEVATOR 2
149