Table of Contents
Advertisement
CONDITION
This function, in the Model menu, can be used
to switch the settings of up to 5 flight conditions.
Please note this is not applicable to airplane type
selections.
Note: To prevent accidental activation of any
unused flight conditions during flight, set the
switch setting of those unused conditions to
null [--].
● A Condition Delay function can be set
to prevent unnecessary fuselage motion
which may be generated when there are
● Select [CONDITION] at the Model menu and
access the setup screen shown below by pushing
the RTN button.
● Select the function name
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Condition switch selection/deletion
1. Move the cursor to the switch item of the
condition you want to select/delete and
access the switch setup screen by pushing
the RTN button and select the switch and ON
direction.
*For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.
Condition copy
(Setup screen page 3)
1. Move the cursor to the [SOURCE] item and
push the RTN button to switch to the data
input mode.
Select the copy source condition by scrolling
the Push dial. Then, push the RTN button.
2. Move the cursor to the [DESTIN.] item and
Flight condition's switch assignment, copy, priority change and
condition delay can be set [except airplane type].
(Currently selected condition name)
(Condition name)
(Condition switch)
sudden changes in the servo positions and
when there are variations in the operating
time between channels during condition
switching. The delay can be set for each
channel to ensure maximum performance
from your aircraft.
When setting the delay function for a specific
flight condition, the related function changes
after a delay corresponding to the set
amount.
● I f m u l t i p l e c o n d i t i o n s w e r e s e t , t h e i r
operational priority may be customized as
desired.
<Push Dial>
push the RTN button.
Select the copy destination condition by
scrolling the Push dial. Then, push the RTN
button.
*The current condition cannot be selected for the copy
destination condition.
3. Move the cursor to the [COPY] item and push
the RTN button. A confirmation message
appears.
*The display blinks.
4. Push the RTN button for one second and the
copying is completed. (Push the S1 button to
stop copying.)
Priority change
1. Move the cursor to the priority up-arrow or
down-arrow you want to change and push
the RTN button.
The priority of the corresponding condition is
changed. (The last condition becomes the
highest priority.)
*The Normal condition cannot be changed or moved. Its
priority is always the lowest.
<Model Menu (Common Functions)>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
127
Advertisement
Table of Contents
