FUTABA T12K Instruction Manual page 176

Throttle limiter function
This function limits the high range of the throttle
movement by any slider or trimmer.
*Control which adjusts the limit point during flight can be set.
Setting method
*Set at the 3rd page of the throttle curve screen.
•Activate the function.
1. Select ACT and push the RTN button.
2. Switch the display to ACT by scrolling the
Push dial.
*The display blinks.
INH: Inhibit
ACT: Activate
3. Enter the selection by pushing the RTN
button.
•ON/OFF switch setting
1. Select SW and push the RTN button.
2. The H/W SET screen is displayed. Select the
hardware and push the RTN button.
When "CTRL" is set as a "RS" side slider.
The state of full high of a throttle stick.
"RS"Position
HIGH
CENTER
In "INH", the halfway
point of "HIGH" and
"LOW".
LOW
176 <Functions of Model Menu (Helicopter Functions)>
[Throttle limiter setting]
•High side operating range setting
1. Select HIGH and push the RTN button.
2. Adjust the high side operating range by
scrolling the Push dial.
*A gauge is displayed at the left side of the graph.
3. Push the RTN button to switch to the cursor
mode.
•Low side operating range setting
1. Select LOW and push the RTN button.
2. Adjust the low side operating range by
scrolling the Push dial.
*A gauge is displayed at the left side of the graph.
3. Push the RTN button to switch to the cursor
mode.
•Limiter operating range adjustment control
setting
1. Select CTRL and push the RTN button.
2. The H/W SET screen is displayed. Select the
hardware and push the RTN button.
Throttle
*The throttle limiter operating position is indicated by a
Position
dotted line on the graph.
Full
*When limiter operating range adjustment control is NULL,
the throttle limiter function is not performed.
Slow
•Changing the control center position
1. Select CENTER and push the RTN button for 1
Full
second. CENTER changes from INH to "rate
display".
2. When the CENTER rate is changed, the
Slow
neutral position of the hardware set at CTRL
can be adjusted.
Full
*When CENTER is INH, the neutral position becomes the
LOW intermediate value.
Slow
*When CENTER is changed from INH to "rate display", the
CENTER rate is set to the LOW intermediate value.
*The CENTER rate can be set between HIGH and LOW.