FUTABA T12K Instruction Manual page 121

TELEMETRY : Current sensor
The SBS-01C has the capability of measuring
current, voltage and capacity (consumption) from
drive battery all at the same time.
Drive
Battery
● Select [CAPACITY] in the TELEMETRY screen
and access the setup screen shown below by
pushing the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
● ↑ An upward arrow
indicates the alarm
will sound when the
c a p a c i t y r e a c h e s
above your set value.
● ↓ A downward arrow
indicates the alarm
will sound when the
c a p a c i t y r e a c h e s
below your set value.
●Capacity alarm setting range -32,000mAh ～ -32,000mAh
(↑THRESHOLD > ↓THRESHOLD)
*Alarm when the
capacity
Alert setting when capacity increases
1. Set "↑ALERT" on the <CAPACITY> screen to
ACT. Move the cursor to INH and push the RTN
button.
2. Select the ACT mode by scrolling the Push dial.
3. Push the RTN button. (To terminate the input
and return to the original state, push the S1
button.)
4. The capacity at which an alarm is generated
can be set by selecting the capacity display
next to "↑ THRESHOLD" and pushing the RTN
button. This generates an alarm when the
capacity increases.
5. Adjust the rate by scrolling the Push dial.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
6. Push the RTN button. (To terminate the input
and return to the original state, push the S1
button.)
[Capacity]
to Receiver
●Push the S1 button to advance to the next page.
has decreased.
Displaying data from the drive battery capacity
*SBS-01C must be installed in the aircraft.
*It cannot be used in S-FHSS mode
ESC
SBS-01C
● Displays the maximum/minimum data
after the transmitter is turned on.
Alert setting when capacity decreases
1. Select page 2 by pushing S1 from the
<CAPACITY> screen and set " ↓ ALERT" to
ACT.
2. Select the ACT mode by scrolling the Push
dial.
3. Push the RTN button. (To terminate the input
and return to the original state, push the S1
button.)
4. The capacity at which an alarm is generated
can be set by selecting the numerical display
next to " ↓ THRESHOLD" and pushing the
RTN button. This sounds an alarm when the
capacity decreases.
5. Adjust the rate by scrolling the Push dial.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
6. Push the RTN button. (To terminate the input
and return to the original state, push the S1
button.)
<Functions of Linkage Menu>
Motor
●Displays the capacity data
<Push Dial>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
● To next page
●Capacity alarm setting range
-32,000mAh ～ -32,000mAh
(↑THRESHOLD > ↓THRESHOLD)
*Alarm when the capacity has increased.
"Vibes" type
If the following types are selected, the
transmitter will vibrate during the warning.
TYPE 1
TYPE 2
TYPE 3
TYPE 4
121