FUTABA T12K Instruction Manual page 185

●Diplay mode selection
*When [rpm] mode is selected above setting, the display
mode can be selected.
* There is no change in the transmitter output even when the
"MODE" is changed. Calibration should be performed via
the governor.
* In order to use the Governor function of the T12K, it is
necessary to change the settings on the governor for the low
side 700rpm mode.
When the MODE of the Governor screen's
model menu is changed, the change is also
indicated on-screen.
The chart below indicates the mode percentage and
the corresponding RPM.
MODE 0％
1000-2000rpm 1000rpm 1500rpm 2000rpm 2100rpm
1000-2500rpm 1000rpm 1500rpm 2500rpm 2700rpm
1000-3500rpm 1000rpm 1500rpm 3500rpm 3900rpm
700-2000rpm 700rpm 1500rpm 2000rpm 2100rpm
700-2500rpm 700rpm 1500rpm 2500rpm 2700rpm
700-3500rpm 700rpm 1500rpm 3500rpm 3900rpm
●Fine tuning VR settings
Move the cursor to the [--] item and push the
RTN button to access the selection screen.
Select the control.
*For a description of the switch selection method, see the
description at the back of this manual.
Move the cursor to the rate item and push
the RTN button to switch to the data input
mode.
Adjust the trim rate by scrolling the Push dial.
Initial value: 0% (0rpm)
Adjustment range: -20~+20% (-200~+200rpm)
*When the RTN button is pushed for one second, the
sensitivity is reset to the initial value.)
Push the RTN button to return to the cursor
mode.
50％ 100％ 110％
<Functions of Model Menu (Helicopter Functions)>
<EXAMPLE>RPM rate is changed with a
switch (SF) irrespective of condition.
Generally, RPM rate is interlocked with a
condition and changes a rate.
How to change two rates in the same
condition.
1. Select [GOVERNOR] at the Model menu
and access the setup screen shown below
by pushing the RTN button.
2. Move the cursor to the [COND] item and
push the RTN button to access the selection
screen. Select the [SW]. Push the RTN button
to return to the cursor mode. And [INH] is
set to [ACT].
3. # number shows the present switch state.
In the state of # 1, a cursor is moved to [--]
and RTN is pushed.
4. [SF] is chosen by [H/W SELECT] and then a
top is turned ON.
5. [MODE] and [RATE] of a state of "#1=SF
top"are set up.
SF : Top = #1
6. It is a setup of "#2". Move the cursor to
the [#1] item and push the RTN button to
access the selection screen. Select the [#2].
Push the RTN button to return to the cursor
mode. And [INH] is set to [ACT].
The number
●
of a SW state
185