Sensor: Relocate; Sensor: Set Slot - FUTABA T12K Instruction Manual

SENSOR : RELOCATE
Use this function when repeated registration
and deregistration of slots has left open slots
fragmented and unusable. It rearranges them into
contiguous unused slots.
● Call page 7 by pushing the S1 button 6 times from
the [SENSOR] menu.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Relocate of sensors to be used
1. Connect all the sensors and receiver
batteries to be used to the T12K through a
hub as shown in the figure above.
2. Move the cursor to "RELOCATE" on page 7 of
the [SENSOR] screen.
3. Push the RTN button.
SENSOR : SET SLOT
This procedure changes the slot number of one
registered sensor.
Sensor slot change
1. Connect the sensor and receiver battery to
be changed to the T12K through a hub as
shown in the figure above.
2. Move the cursor to "SET SLOT" on page 7 of
the <Sensor> screen.
3. Push the RTN button. A sensor details screen
appears.
4. Move the cursor to "LOAD" and push the RTN
button.
5. The current start slot is displayed. Move the
cursor to the number of the start slot and
change it to the desired value.（Cannot be
set to a slot that cannot be allocated like the
table of all pages.）
6. Move the cursor to "WRITE" and push the RTN
button.
124 <Functions of Linkage Menu>
Follow these instructions when using multiple telemetry sensors of the same type.
This page is for using multiple telemetry sensors of the same type.
3-way hub
or Y-harnesses
Receiver's
battery
All the sensors to be used are connected.
<Push Dial>
Scrolling
● Moving cursor
● Data is entered
● To next page
3-way hub
or Y-harnesses
Receivers
battery