Program Mix - FUTABA T12K Instruction Manual

PROG. MIX
Programmable mixing may be used to correct
undesired tendencies of the aircraft, and it may also be
used for unusual control configurations. Mixing means
that the motion of a command channel, called the
"master," is added to the motion of the mixed channel,
called "slave."
You may choose to have the Master's trim added to
the Slave channel response ("Trim" setting). The mixing
● Select [PROG. MIX] at the Model menu and
access the setup screen shown below by pushing
the RTN button.
● Select the function name
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
●Mix #
● Move the cursor to the mix # whose function you want to activate
and access the setup screen by pushing the RTN button.
●Mixing rate (Left/right, up/down)
[Linear curve]
●Curve selection
●Current mix No.
●Slave CH
●Master CH
Program mixing can be freely customized. Up to five mixings can
be used for each model. [All model types]
Mix setup screen call
●Offset rate(X, Y)
●Switch selection
●ON/OFF
●Link setting
●Trim mode setting
curve (Linear/5-point) can be changed. You may select
Mixing ON/OFF switch, control or you may choose to
have mixing remaining on all the time.
The Programmable mixing includes a powerful link
function, which allows Programmable mixing to be
linked with the special mixing functions, or with other
programmable mixing functions. The link function can
be set up for Master and Slave channel individually.
<Push Dial>
[5-point curve]
●Curve selection ●Point rate (point1-5)
Prog. mix setting procedure
●Activate the function.
Move the cursor to the [ACT] item and push
the RTN button to switch to the data input
mode.
Select the ACT mode by scrolling the Push
dial.
*The display blinks.
Push the RTN button to activate the function
and return to the cursor mode.
*The function is activated. (ON or OFF display)
*ON/OFF switch and mix rate are not set even though the
function is activated.
<Model Menu (Common Functions)>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
● To next page
131