Home Screen - FUTABA T12K Instruction Manual

Home Screen

Use the Push dial to select the following display area to call each setting screen, and push the RTN
button. The setting screen appears.
System timer
• This shows the accumulated time since
the latest reset. (Hour):(Minute)
• Use the cursor to highlight this, then
push the RTN button for one second
to reset the system timer.
Up/Down timer (ST1, ST2)
• Timer is displayed here.
Push the RTN button at the [xx]:[xx.xx]
item to start/stop the timer.
• Use the cursor to highlight this, then
push the RTN button at the ST1 or ST2
item to call the timer setup screen.
*See the description at the back of this manual.
User name
RF indicator
System mode
• System(T-FHSS Air or S-FHSS)
mode is displayed here.
• Use the cursor to highlight this,
then push the RTN button to call
the frequency set-up screen.
Digital trim (T1 to T4)
• Trim position is displayed here.
• You can select the display unit
on the home screen on the
T1-T4 setting screen within the
linkage menu.
nd
2 Home screen
• Push the RTN button at
the clock icon to call the
nd
2 home screen (large
size timer).
40 <Basic Operation>
Key lock
• Push the S1 button or push the HOME/
EXIT button for one second to lock/
unlock the key operation.
In the key lock mode the key icon is
displayed here.
micro SD card indicator
Battery Indicator
• When the battery voltage
r e a c h e s 5 . 6 V ( C h a n g e i n
Warning Menu), the alarm
will beep. Land your aircraft
immediately.
• The model name that
• U s e t h e c u r s o r t o
Model timer
• This shows the accumulated time
since the latest reset. (each model)
(Hour):(Minute)
• Use the cursor to highlight this, then
push the RTN button for one second
to reset the model timer.
Condition name (Heli/Glider)
• In the normal condition, move the
cursor to the condition name and
push the RTN button. The condition
name is changed and blinks.
It is possible to operate the digital
trim in all conditions.
VPP condition # (Air)
• When VPP function is assigned to a
channel, the current VPP condition
# is displayed here.
Model type
Model Name
is currently used is
displayed here.
highlight this, then
push the RTN button
t o c a l l t h e m o d e l
select set-up screen.