Table of Contents
Advertisement
Setting method
●Master/single mode selection
Move the cursor to the [MODE] item and
push the RTN button to switch to the data
input mode. Select the master or single
mode by scrolling the Push dial.
*The display blinks.
[MASTER]: Master mode
[SINGLE]: Single mode
Push the RTN button to select the mode and
return to the cursor mode.
When setting a master switch, move the
cursor to the [MASTER-SW] item and push the
RTN button to access the selection screen.
Select the switch and set its ON direction.
*For a description of the switch selection method, see the
description at the back of this manual.
When setting a safety switch, move the
cursor to the [SAFETY-SW] item and push the
RTN button to access the selection screen.
Select the switch and set its ON direction.
●Direction switch selection
Move the cursor to the direction switch
item and push the RTN button to access the
selection screen. Select the switch and set its
ON direction.
*For a description of the switch selection method, see the
description at the back of this manual.
●Rate adjustment
Move the cursor to the aileron, elevator or
rudder item for each direction and push the
RTN button to switch to the data input mode.
Adjust the rate independently by scrolling
the Push dial.
Initial value: (Dependent upon the snap roll
direction)
Adjustment range: -150~+150%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
Push the RTN button to end the adjustment
and return to the cursor mode.
168
<Model Menu (Airplane/Glider/Multirotor Functions)>
Advertisement
Table of Contents
