FUTABA T12K Instruction Manual page 160

When setting a rate selection switch, move
the cursor to the switch item and push the
RTN button to access the selection screen.
Select the switch and set its ON direction.
(Always ON at "--" setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Gyro type selection
Move the cursor to the gyro type selection
item and push the RTN button to switch to
the data input mode. Select the gyro type
by scrolling the Push dial.
[GY]: When a Futaba GYA gyro is used
[NORM]: When using something other than
Futaba GYA gyro is used.
Push the RTN button to change the gyro type
and return to the cursor mode.
*When a Futaba GYA gyro is used and [GY] type is selected,
the sensitivity set value is directly read in both AVCS and
NORM modes.
●Operation mode selection (GYA gyro)
Move the cursor to the operation mode
(Example) Setting three axis using a GYA440 and GYA441 (2)
● Wing type: 2 fuselage-mounted aileron servos selected.
5CH → GYRO
● Set
and TRIM → [--]
● GYRO setting of the Model menu.
Rate
#1
#2
#3
*Set so that Rate 1 is turned on at the back position of switch E and Rate 3 is turned ON at the front position. Since
switch E is turned OFF at the center, Rate 2 remains [INH].
Receiver
S.BUS/S.BUS2 port
160 <Model Menu (Airplane/Glider/Multirotor Functions)>
7CH → GYRO2
(GYA441AIL),
: at the Function menu of the Linkage menu.
GYRO GYRO ２
AVCS : 60% AVCS : 60% AVCS : 60%
NORM : 60% NORM : 60% NORM : 60%
GYA441
GYA441
GYA440
selection item and push the RTN button to
switch to the data input mode. Select the
operation mode by scrolling the Push dial.
[AVCS]: AVCS mode
[NORM]: Normal mode
Push the RTN button to change the operation
mode and return to the cursor mode.
●Sensitivity setting
Move the cursor to the sensitivity icon and
push the RTN button to switch to the data
input mode.
Adjust the sensitivity by scrolling the Push dial.
Initial value: 0%
Adjustment range: 0~100%
*When the RTN button is pushed for one second, the
sensitivity is reset to the initial value.)
Push the RTN button to return to the cursor
mode.
8CH → GYRO3
(GYA441ELE),
GYRO ３ TYPE ACT/INH
GY OFF/ON
GY ON/OFF
Aileron servo
Elevator servo
Rudder servo
CTRL
(GYA440RUD),
SW
SE
INH
SE
AVCS
GAIN 0％
NORMAL
When AVCS is used, we
recommend that the
sensitivity CH be set to
the 3-position.