Hardware Access-List Capture - Cisco Nexus 7000 Series Command Reference Manual

H Commands

hardware access-list capture

To enable access control list (ACL) capture on all virtual device contexts (VDCs), use the hardware access-list
capture command. To disable ACL capture, use the no form of the command.
hardware access-list capture
no hardware access-list capture
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
Release
6.1(1)
5.2(1)
Usage Guidelines
Only M Series modules support ACL capture.
ACL capture is a -assisted feature and is not supported for the management interface or for control packets
originating in the supervisor. It is also not supported for software ACLs such as SNMP community ACLs and
virtual teletype (VTY) ACLs.
Enabling ACL capture disables ACL logging for all VDCs and the rate limiter for ACL logging.
Only one ACL capture session can be active at any given time in the system across VDCs.
This command does not require a license.
Examples
This example shows how to enable ACL capture on all VDCs:
switch# configure terminal
switch(config)# hardware access-list capture
This example shows how to disable ACL capture on all VDCs:
switch # configure terminal
switch(config)# no hardware access-list capture
Modification
Added support for M2 series modules.
This command was introduced.
Cisco Nexus 7000 Series Security Command Reference
hardware access-list capture
349