Show Ip Arp Inspection Vlan - Cisco Nexus 7000 Series Command Reference Manual

Show Commands

show ip arp inspection vlan

Use the show ip arp inspection vlan command to display Dynamic ARP Inspection (DAI) status for the
specified list of VLANs.
show ip arp inspection vlan vlan-list
Syntax Description
vlan-list
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History
Release
4.0(1)
Examples This example shows how to display DAI status for VLANs 1 and 13:
switch# show ip arp inspection vlan 1,13
Source Mac Validation
Destination Mac Validation : Enabled
IP Address Validation
Vlan : 1
-----------
Configuration
Operation State
Vlan : 13
-----------
Configuration
Operation State
switch#
Modification
This command was introduced.
: Enabled
: Enabled
: Enabled
: Active
: Enabled
: Inactive
VLANs with DAI status that this command shows.
The vlan-list argument allows you to specify a single
VLAN ID, a range of VLAN IDs, or
comma-separated IDs and ranges (see the "Examples"
section). Valid VLAN IDs are from 1 to 4096.
Cisco Nexus 7000 Series Security Command Reference
show ip arp inspection vlan
789