Cisco Nexus 7000 Series Command Reference Manual page 702

switchport port-security
This example shows how to enable port security on the port-channel 10 interface:
switch# configure terminal
switch(config)# interface port-channel 10
switch(config-if)# switchport port-security
switch(config-if)#
Related Commands
Command
feature port-security
show port-security
switchport port-security aging time
switchport port-security aging type
switchport port-security mac-address
switchport port-security mac-address sticky
switchport port-security maximum
switchport port-security violation
Cisco Nexus 7000 Series Security Command Reference
676
Description
Enables port security globally.
Shows information about port security.
Configures the aging time for dynamically learned,
secure MAC addresses.
Configures the aging type for dynamically learned,
secure MAC addresses.
Configures a static MAC address.
Enables the sticky method for learning secure MAC
addresses.
Configures an interface or a VLAN maximum for
secured MAC addresses on an interface.
Configures the security violation action for an
interface.
S Commands