Cisco Nexus 7000 Series Security Command Reference - Cisco Nexus 7000 Series Command Reference Manual

cts dot1x
Command
show cts interface
Related Commands
Release
4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
You can use only IPv4 addressing with Cisco TrustSec.
This command requires the Advanced Services license.
Examples This example shows how to configure Layer 3 Cisco TrustSec global mapping for an SPI and subnet:
switch# config t
switch(config)# cts l3 spi 3 10.10.1.1/23
This example shows how to remove Layer 3 global mapping for a subnet:
switch# config t
switch(config)# no cts l3 spi 10.10.1.1/23
Related Commands
Command
feature cts
show cts l3 mapping

Cisco Nexus 7000 Series Security Command Reference

66
Description
Displays Cisco TrustSec configuration information
for interfaces.
Modification
This command was introduced.
Description
Enables the Cisco TrustSec feature.
Displays the Layer 3 Cisco TrustSec mapping for SPI
values to IPv4 subnets.
C Commands