Cisco Nexus 7000 Series Security Command Reference - Cisco Nexus 7000 Series Command Reference Manual

Hide thumbs Also See for Nexus 7000 Series:

Table of Contents

packet-lengthoperatorpacket-length [packet-length

Command Default

A newly created IPv4 ACL contains no rules.

If you do not specify a sequence number, the device assigns the rule a sequence number that is 10 greater than

the last rule in the ACL.

(TCP only; Optional) TCP control bit flags that the

rule matches. The value of the flags argument must

be one or more of the following keywords:

(TCP only; Optional) Specifies that the rule matches

only packets that belong to an established TCP

connection. The device considers TCP packets with

the ACK or RST bits set to belong to an established

(Optional) Rule matches only packets that have a

length in bytes that satisfies the condition specified

by the operator and packet-length arguments.

Valid values for the packet-length argument are whole

numbers from 20 to 9210.

The operator argument must be one of the following

• eq—Matches only if the packet length in bytes

is equal to the packet-length argument.

• gt—Matches only if the packet length in bytes

is greater than the packet-length argument.

• lt—Matches only if the packet length in bytes

is less than the packet-length argument.

• neq—Matches only if the packet length in bytes

is not equal to the packet-length argument.

• range—Requires two packet-length arguments

and matches only if the packet length in bytes

is equal to or greater than the first packet-length

argument and equal to or less than the second

packet-length argument.

Cisco Nexus 7000 Series Security Command Reference