Managing The Switch; Displaying Information About The Installed Hardware Modules - Cisco Nexus 9508 NX-OS Hardware Installation Manual

Managing the Switch

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Displaying Information About the Installed Hardware Modules

You can display information about the switch hardware and the hardware modules that are installed in the
switch chassis by using the show hardware command.
switch# show hardware
Cisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Documents: http://www.cisco.com/en/US/products/ps9372/tsd_products_support_seri
es_home.html
Copyright (c) 2002-2013, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
other third parties and are used and distributed under license.
Some parts of this software are covered under the GNU Public
License. A copy of the license is available at
http://www.gnu.org/licenses/gpl.html.
Software
...
Hardware
Displaying Information About the Installed Hardware Modules, on page 49
Displaying the Hardware Inventory for a Switch, on page 53
Displaying the Backplane and Serial Number Information, on page 54
Displaying Environmental Information for the Switch, on page 56
Displaying the Current State of a Module, on page 57
Displaying Temperatures for a Module, on page 59
Connecting to a Module, on page 60
Saving the Module Configuration, on page 61
Shutting Down or Starting Up a Module, on page 62
Purging a Nonfunctioning Module from the Running Configuration, on page 63
Displaying Power Usage Information, on page 63
Reload a Module, on page 64
Rebooting a Switch, on page 65
Overview of Supervisor Modules, on page 65
Overview of Power Modes, on page 67
Overview of Fan Trays, on page 72
C H A P T E R
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
5
49