Chapter 6
Cajun Campus CLI – Layer 2
host%
To reset module 4:
Cajun_P330-N# reset 4
This command will reset module 4 and may disconnect your
telnet session.
Do you want to continue (y/n) [n]? y
Resetting module 4...
Nvram initialize Command
Use the nvram initialize command to reset the Avaya P330 parameters to the
factory defaults. If no options are specified for this command, only the Layer 2
parameters will be reset.
The syntax for this command is:
nvram initialize [switch|all]
switch
all
Example:
Cajun_P330-N# nvram initialize
This command will force a factory default and switch-over to
the master module and disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Connection closed by foreign host.
host%
Configure Command
The configure command is not used in the Avaya P333T switch but is used with
the P333R-LB Router. (please see the P333R-LB User Guide).
106
Resets all the switching level parameters (Layer 2 only) throughout
the stack
Resets all parameters including routing parameters of the
Cajun P333R modules present in the stack
Avaya P333T User's Guide