Installing the Expansion Sub-module in the Avaya P330
1
Remove the blanking plate or other sub-module (if installed).
2
Insert the sub-module gently into the slot, ensuring that the Printed Circuit
Board (PCB) is aligned with the guide rails.
The PCB not the metal base plate fits into the guide rail.
3
Press the sub-module in firmly until it is completely inserted into the
Cajun P330.
4
Gently tighten the two screws on the front panel of the expansion sub-module
by turning the screws.
Note: The expansion sub-modules contain components sensitive to electrostatic
discharge. Do not touch the circuit board unless instructed to do so.
Removing an Existing Expansion Sub-module
1
Loosen the screws by turning the knobs.
2
Grasp the two knobs one near each side of the front panel, and pull gently but
firmly towards yourself.
3
Insert another expansion sub-module or the blanking plate.
Note: The Avaya P330 switch must not be operated with the expansion slot open;
the expansion sub-module should be covered with the supplied blanking plate if
necessary.
Note: X330GT2 sub-modules are hot swapable and can be inserted or removed in an
operating base unit.
Cabling
A Category 5 copper cable with RJ-45 termination should be used. You should use
all eight wires in the cable.
The maximum copper cable length connected to a 1000Base-T port is 100 m
(328 ft.)
Avaya P333T User's Guide
Appendix B
Specifications
131