Installing And Configuring An Snmp Agent On Solaris; Prerequisites; Installing Snmp On Solaris; Lsi Sas Snmp Mib Location - Lenovo ThinkServer RD650 User Manual

12Gb/s MegaRAID SAS Software User Guide
March 2014
You can install SNMP without the trap functionality. To do so, set the TRAPIND environment variable to "N" before
running RPM.
Before you install a new version, you must uninstall all previous versions.
For the SLES 10 operating system, perform the following steps to run SNMP:
1. Copy /etc/snmp/snmpd.conf to /etc/snmpd.conf.
2. Modify the /etc/init.d/snmpd file, and change SNMPDCONF=/etc/snmp/snmpd.conf entry to
SNMPDCONF=/etc/snmpd.conf.
3. Run LSI SNMP rpm.
7.6.5

Installing and Configuring an SNMP Agent on Solaris

This section explains how to install and configure SAS SNMP Agent for the Solaris operating system.
7.6.5.1

Prerequisites

This package requires that you have Solaris System Management Agent installed on the Solaris machine.
7.6.5.2

Installing SNMP on Solaris

To install SNMP for the Solaris operating system, perform the following steps:
1. Unzip the LSI SAS SNMP Agent package.
2. Run the install script by using the following command:
# ./install.sh
The installation exits if any existing versions of storelib and sassnmp are installed on the Solaris machine. Uninstall the
existing version by using the following commands:
# pkgrm sassnmp (to uninstall the LSI SAS SNMP Agent)
# pkgrm storelib (to uninstall storelib library)
7.6.5.3

LSI SAS SNMP MIB Location

After you install the LSI SAS SNMP Agent package, the MIB file LSI-AdapterSAS.mib is installed under
/etc/lsi_mrdsnmp/sas directory.
7.6.5.4

Starting, Stopping, and Checking the Status of the LSI SAS SNMP Agent

The following commands are used to start, stop, restart, and check the status of the Solaris System Management
Agent (net snmpd) daemon on Solaris 10 x86 and Solaris 10 SPARC:
NOTE To receive a trap in a local machine with Net-SNMP version 5.3, you
must modify the snmptrapd.conf, file (generally located at
/var/net-snmp/snmptrapd.conf). Add
disableAuthorization yes in snmptrapd.conf and then
run sudo snmptrapd -P -F "%02.2h:%02.2j TRAP%w.%q
from %A %v\n.
NOTE It is assumed that snmpd.conf is located in/etc/snmp for the Red
Hat operating system and /etc for the SLES operating system. You
can change the file location from the
/etc/init.d/lsi_mrdsnmpd file.
NOTE While installing the SAS SNMP Agent on Solaris 11, the net-snmp
package needs to be installed on the machine.
LSI Corporation
- 223 -
Chapter 7: MegaRAID Storage Manager Overview and Installation
Installing and Configuring an SNMP Agent