Lenovo ThinkServer RD650 User Manual page 158
12 gb/s megaraid sas
Hide thumbs
Also See for ThinkServer RD650:
- User manual and hardware maintenance manual (262 pages) ,
- Operating system installation manual (122 pages) ,
- User manual (226 pages)
Table of Contents
Advertisement
12Gb/s MegaRAID SAS Software User Guide
March 2014
The StorCLI syntax uses the following general format:
<[object identifier]> <verb> <[adverb | attributes | properties] > <[key=value]>
The StorCLI tool supports the object identifiers listed in the following table.
Table 35 Object Identifiers in the StorCli Command Syntax
Object Identifier
No object identifier specified If there is no object identifier, the command is a system command.
/cx
/cx/vx
/cx/vall
/cx/ex
/cx/eall
/cx/fx
/cx/fall
/cx/ex/sx
/cx/sx
/cx/ex/sall
/cx/dx
/cx/dall
/cx/px
/cx/pall
/cx/bbu
/cx/cv
The StorCLI tool supports the following verbs.
NOTE
JSON format output is not supported in the EFI operating system. The
EFI platform ignores the J when it is added at the end of the command
syntax.
NOTE
Background operations are blocked in the EFI and HII environments
and these operations are resumed in the operating system
environments.
This object identifier is for controller x.
This object identifier is for a virtual drive x on controller x.
This object identifier is for all virtual drives on controller x.
This object identifier is for an enclosure x on controller x.
This object identifier is for all enclosures on controller x.
This object identifier is for a foreign configuration x on controller x.
This object identifier is for all foreign configurations on controller x.
This object identifier is for the drive is slot x on enclosure x on controller x.
This object identifier represents the drives that are directly attached to controller x.
This object identifier is for all the drives on enclosure x on controller x.
This object identifier is for the drive group x on enclosure x on controller x.
This object identifier is for the all drive groups on enclosure x on controller x.
This object identifier is for a PHY operation x on controller x
This object identifier is for all PHY operations on controller x
This object identifier is for a BBU x on controller x
This object identifier is for a cache vault x on controller x
NOTE
If enclosures are not used to connect physical drives to the controller,
you do not specify the enclosure ID in the command.
Description
LSI Corporation
- 158 -
Chapter 6: StorCLI
StorCLI Command Syntax
Advertisement
Table of Contents
