Installing And Configuring An Snmp Agent On Solaris - Lenovo ThinkServer RD240 Software User's Manual

6.6.2

Installing and Configuring an SNMP Agent on Solaris

6.6.2.1 Prerequisites
6.6.2.2 Installation SNMP on Solaris
6-28
2. Modify the /etc/init.d/snmpd file and change
SNMPDCONF=/etc/snmp/snmpd.conf entry to
SNMPDCONF=/etc/snmpd.conf.
3. Run ThinkServer SNMP rpm
This section explains how to install and configure SAS SNMP Agent for
the Solaris operating system. To install and configure SNMP for Solaris,
perform the procedures described in the following sections:
– Section 6.6.2.1, "Prerequisites"
– Section 6.6.2.2, "Installation SNMP on Solaris"
– Section 6.6.2.3, "ThinkServer SAS SNMP MIB Location"
– Section 6.6.2.4, "Starting, Stopping, and Checking the Status of
the ThinkServer SAS SNMP Agent"
– Section 6.6.2.5, "Configuring snmpd.conf"
– Section 6.6.2.6, "Configuring SNMP Traps"
– Section 6.6.2.7, "Uninstalling the SNMP Package"
This package requires that you have Solaris System Management Agent
installed on the Solaris machine.
To install SNMP for Solaris, perform the following procedure:
Step 1. Unzip the ThinkServer SAS SNMP Agent package.
Step 2. Run the install script by executing the following command:
# ./install.sh
Note: The installation will exit if there are any existing versions of
storelib and sassnmp installed on the Solaris machine.
MegaRAID Storage Manager Overview and Installation
.