Cachevault Commands; Enclosure Commands - Lenovo ThinkServer RD650 User Manual

12Gb/s MegaRAID SAS Software User Guide
March 2014
storcli /cx/bbu set learnStartTime=[DDD HH| off]
This command sets the learn start time for the BBU in hours on the day specified. DDD refers to the day of the week
(SUN,MON,....SAT), HH refers to the hours (0-23 hours), and offsets the learn start to off.
Input example:
storcli /c0/bbu set learnStartTime=MON 12
storcli /cx/bbu show properties
This command shows the BBU Learn properties for a controller.
Input example:
storcli /c0/bbu show properties
storcli /cx/bbu show status
This command shows the battery information, firmware status, and the gas gauge status.
Input example:
storcli /c0/bbu show status
storcli /cx/bbu start learn
This command starts the BBU learning cycle. The battery learn cycle is immediately started and no other parameters
are required for this command.
Input example:
storcli /c0/bbu start learn
storcli /cx/bbu start retentiontest
This command starts the battery retention test. This command requires you to reboot your system.
Input example:
storcli /c0/bbu start retentiontest
6.6.10

CacheVault Commands

The Storage Command Line Tool supports the following CacheVault command:
storcli /cx/cv show all
storcli /cx/cv show all
This command shows all the information of a CacheVault that is connected to a controller.
Input example:
storcli /c0/cv show all
6.6.11

Enclosure Commands

The Storage Command Line Tool supports the following enclosure commands:
storcli /cx/ex download src=filepath[forceActivate]
storcli /cx/ex show all
NOTE This command only works when a CacheVault is connected to the
controller; else an error message appears.
LSI Corporation
- 195 -
Chapter 6: StorCLI
Working with the Storage Command Line Tool