Virtual Drive Initialization Commands - Lenovo ThinkServer RD650 User Manual
12 gb/s megaraid sas
Hide thumbs
Also See for ThinkServer RD650:
- User manual and hardware maintenance manual (262 pages) ,
- Operating system installation manual (122 pages) ,
- User manual (226 pages)
Table of Contents
Advertisement
12Gb/s MegaRAID SAS Software User Guide
March 2014
storcli /c0/v0 set rdcache=nora
storcli /cx/vx|vall set ssdcaching=<on|off>
This command assigns CacheCade virtual drives. If ssdcaching=off, the CacheCade virtual drive is removed.
Input example:
storcli /c0/v0 set ssdcaching=on
storcli /cx/vx|vall set HostAccess=ExclusiveAccess|SharedAccess
This command sets the host access policy for the virtual drive. when the host access policy is exclusive access, a server
has exclusive access to the virtual drive. The virtual drive cannot be shared between servers. If the host policy is shared
access, then the virtual drive can be shared between servers.
Input example:
storcli /c0/v0 set HostAccess=ExclusiveAccess
storcli/cx/vx set wrcache=<wt|wb|awb>
This command sets the write cache policy on a virtual drive to write back, write through, or always write back.
Input example:
storcli /c0/v0 set wrcache=wt
6.6.4.6
Virtual Drive Initialization Commands
The Storage Command Line Tool supports the following commands to initialize virtual drives:
storcli /cx/vx show init
storcli /cx/vx start init [full][Force]
storcli /cx/vx stop init
The detailed description for each command follows.
storcli /cx/vx show init
This command shows the initialization progress of a virtual drive in percentage.
The estimated time (in minutes) left to complete the operation is also shown.
Input example:
storcli /c0/v2 show init
storcli /cx/vx start init [full]
This command starts the initialization of a virtual drive. The default initialization type is fast initialization. If the
fulloption is specified, full initialization of the virtual drive starts.
Input example:
storcli /cx/vx start init [full]
storcli /cx/vx stop init
This command stops the initialization of a virtual drive. A stopped initialization cannot be resumed.
NOTE
If the virtual drive has user data, you must use the force option to
initialize the virtual drive.
A virtual drive with a valid MBR and partition table is considered to
contain user data.
LSI Corporation
- 184 -
Chapter 6: StorCLI
Working with the Storage Command Line Tool
Advertisement
Table of Contents
