Sp6-Xxx (Peripherals) - Ricoh J-P3 Service Manual

20 February 2004

SP6-XXX (Peripherals)

6110 [Punch]
Adjusts the punching position.
Punch 1
Punch 2
Increment: Holes move toward the paper center.
Decrement: Holes move toward the paper edge.
6110 001 MF Fin 1
6110 002 MF Fin 2
6110 003 Booklet Fin
6111 [Staple Position]
Adjusts the stapling position.
Increment: Staple position moves toward the edge of paper.
Decrement: Staple position moves toward the center of paper.
NOTE: Although the adjustable range is ±3.5 mm, the stapling position can be
changed only by 1.0 mm when stapling one position at the front or rear side even
when the input value is more than 1.0.
6111 001 MF Fin
6111 002 Booklet Fin
6112 [Fold Position]
6111 001 A3/DLT
6111 002 B4/LG
6112 003 A4/LT
6112 004 A3/DLT
6112 005 B4/LG
6112 006 A4/LT
6901 [Multi Bin Set]
Specifies whether or not the optional multi-bin output tray is installed. When
installing the multi-bin output tray, this SP mode should be set to "1".
6901 001 Multi Bin Set
US: 2 punch holes
Europe: 2 punch holes
North Europe: 4 punch holes
US: 3 punch holes
Europe: 4 punch holes
*BCU
*BCU
*BCU
*BCU
*BCU
5-47
ENGINE SERVICE MODE
[-7.5 to 7.5 / 0 / 0.5 mm/step]
[-2.5 to 7.5 / 0 / 0.5 mm/step]
[-3.5 to 3.5 / 0 / 0.5 mm/step]
[-3.75 to 3.75 / 0. / 0.25 mm/step]
[-3.75 to 3.75 / 0. / 0.25 mm/step]
Adjusts the folding positions of the optional
booklet finisher.
[0 or 1 / 0 / -] Not used
0: Not Set, 1: Set