Nvram On The Controller - Ricoh J-P3 Service Manual

20 February 2004

NVRAM on the Controller

1. Start the SP mode.
2. Use SP5-990 to print out the SMC reports ("SP Mode Data" and "Logging
Data") if possible.
3. Use SP5-824 to upload the NVRAM data if possible.
4. Turn off the main power switch and unplug the power cord.
5. Replace the NVRAM on the controller and reassemble the machine.
6. Plug in the power cord.
7. Turn on the main power switch.
8. Start the SP mode.
9. Use SP5-825 to download the NVRAM data if possible. If it can be done, the
following steps are not required.
10. Use Memory Clear (SP5-801) to reset this data:
• SCS (SP5-801-003)
• PRT (SP5-801-008)
• NCS (SP5-801-011)
11. Do Counter Clear (SP7-808).
12. Make these contract-related settings:
• Counter Method (SP5-045)
• Double Count (SP5-104)
• Telephone Number Setting > Fax Telephone Number (SP5-812-002) if the
meter charge mode (SP5-930-001) is "ON" (enabled)
13. Enter the SP mode changes previously made at the factory and the field.
ELECTRICAL COMPONENTS
3-23